Installation Procedures Of Plastic Wood Flooring

Plastic-wood floor is a composite floor made of Plastic-wood material, which has the high quality of environmental protection, moisture-proof and waterproof. So what should we pay attention to when installing plastic wood flooring? First, before the installation of Plastic-wood flooring 1. From the professional point of view of the installation of flooring, before starting the installation work, we must keep the plastic-wood flooring dry, flat and clean in good condition, so as to better ensure the smooth follow-up installation work. 2. Prepare to install tools such as electric drill, common woodworking tools, labor gloves, stainless steel screw and so on. Electric drill is the necessary tool for installing plastic wood floor. Plastic wood flooring is brittle. When fixing the floor and keel, it is necessary to use electric drills and lead holes, and then fix them with screws to avoid damaging the plastic wood flooring. 2. Installation process of plastic floor 1. Fixed Plastic-wood keel: lay Plastic-wood keel evenly on the cement floor. It is suggested that the spacing of each keel should be 30 cm. Drill holes on keel with electric drill. The diameter of the hole should not be less than the diameter of the screw. Then screw the screw into the hole drilled and fix the keel on the cement floor. The head of the nail should be all screwed into the keel. Do not expose it, otherwise it may lead to uneven floor layout. 2. Fixed the first floor: There are Yin and Yang grooves on the left and right sides of each plastic wood floor. When the first floor is paved, the anode groove on the outside of the first floor can be sawed or ground with woodworking tools, and then the nail is opened and screwed into the surface of the floor by electric drill and fixed on the keel. 3. Fixed the second floor: clamp the positive groove of the second plastic wood floor to the position of the negative groove of the first floor, then drill the lead hole on the side surface of the positive groove of the second floor, and screw in the screw to fix it on the keel. The screw spacing can be controlled by the constructors themselves in the installation process, without too dense, so as to ensure that it is firm. The installation of the plastic-wood floor in the back is the same as that in the front, so there is no need to explain more.