What Are The Problems In The Installation Of Solid Wood Flooring

Apr 12, 2019

Leave a message

Installation costs labor and materials, and noise is high. After installation, wood flooring is prone to many problems. Single-layer solid wood floor complaints are more about tile deformation, drying cracks, moving noise. The phenomenon of tile deformation of single-layer solid wood floor in use mostly appears in the hall. Why?






Should they appear in the hall instead of in the bedroom or less? Why do the deformations of plate tiles also occur in the halls of houses and old buildings which have been completed for several years? Why does tile deformation still occur when a layer of plastic film or a layer of moisture-proof film is laid on it? Most people can't think about it.






Solution.




The main reason for tile deformation of wood flooring in use is that the wood fibers have been sealed by multi-layer paint on the board surface. The multi-layer paint film has a certain degree of hardness, which produces a stable tension on the surface. The moisture absorption at the bottom of the board expands and the size of the board has not changed. New Delivery and Use






The moisture content of the walls and floors of houses is over 30%, that is, the houses that have been working for several years are not resident for a long time. The moisture content of closed buildings with doors and windows is also difficult to reduce. When the moisture content of dry wood floors (moisture content < 13%) occurs at the bottom of the board, the expansion plate will become tile-shaped, nails can not be blocked.






Stop this distortion.




When the water content of the building gradually decreases below 8%, the wooden wedge and keel will shrink and loosen, and the keel will also be deformed. It is unavoidable that there is a gap between them due to loose deformation and noise when people move around.




Whether new or old buildings, the causes of serious plate tile deformation in the hall: in the interior decoration process, bathroom, kitchen tiles, floor tiles, in the hall and ash, a large amount of water infiltrated into the floor, the wind blows the surface seems to be dry, the actual floor still exists inside.






A lot of water.




When the wooden floor is finished, a large amount of moisture in the latent floor is absorbed by the wooden floor floor floor, which causes the floor to expand and cause the plate to deform. Although some people lay a plastic film or foam film on the ground, if the film has holes in the ground water will continue to enter the film, especially around the film.






Without turning over to the board and pressing under the kickboard, the water in the wall and the environment will enter the floor from the expansion and contraction joints around the floor. Because the floor has a layer of moisture-proof film into the bottom of the board, the water can not emit out, only the dry wood floor absorbs, resulting in plate deformation. Especially single-layer solid wood flooring






Without scientific drying and manufacturing, it is not surprising that deformation occurs.




The same is true for dry shrinkage cracks. The moisture content of the popular single-layer solid wood flooring in the market can basically meet the stipulated standards. When dry shrinkage cracks occur in the use of single-layer solid wood flooring, tile deformation manufacturers will not bear any responsibility. To reduce the quality of solid wood flooring after installation






The problem should not use keel to fix wood floor, polystyrene Extrusion insulation board should be better than wood keel, simple pavement without nail keel, thermal insulation, heating, cold insulation, moisture-proof, corrosion resistance, good elasticity. More importantly, we should choose scientific and practical solid wood composite floor which is popular all over the world.






There are no worries about demonstrating your wisdom. Especially the designers of engineering projects and fine decoration houses should pay attention to this.


Send Inquiry